Operator Extruder at FlexFilms

Requirements

• Select machine dies.
• Determine setup procedures.
• Draw or press metal into shapes and diameters.
• Reel extruded products into rolls.
• Specify lengths and weights of rolls.
• Replace worn dies.
• Set controls to regulate vacuum, air pressure, sizing rings, and temperature.
• Synchronize speed of extrusion.
• Read and interpret blueprints and drawings.
• Locate defects on extruded products.
• Check for conformance to specifications.
• Adjust controls as necessary.
• Splice cables.
• Install, connect, test, and adjust equipment.
• String lines or install terminal boxes.
• Clean tools.
• Position insulation over conductors.
• Seal splices with moisture-proof covering.
• Access areas by climbing pols and ladders.
• Remove excess, entangled, or completed filaments from machines.
• Operate machines that extrude filaments from synthetic materials such as rayon, fiberglass, or liquid polymers.
• Start metering pumps.
• Activate and adjust extruding machines.