Compression Management Technician at Hyprops Nigeria Limited

Reports To: COO

Job Summary

The CMT would be responsible for management of all processes in a Control Room.

Roles & Responsibilities

• Read and interpret diagrams and schematic drawings and related technical information to determine work procedures;
• Perform the assembly, installation, inspection, maintenance, repair and overhaul of  compression equipment;
• Complete ignition analysis, fuel, air, exhaust and engine management systems testing, fault diagnoses and repair;
• Complete reciprocating and rotating machinery analysis to determine equipment condition, prediction to failure, corrective and preventative measures, and equipment performance to design intent;
• Perform visual walk-around inspections to determine the external conditions and obvious operational or safety issues;
• Use a variety of electrical, mechanical and specialty diagnostic test equipment to diagnose problems and adjust engine systems;
• Provide preventative and corrective field mechanical services on the compression, processing and production equipment on-site at the facility

Job Status:

Permanent

Job Specification:

    Bachelors degree in an engineering discipline
    10+ Oil & Gas Experience
    Good practical knowledge of international Oil & Gas norms and standards

go to method of application »

Reports To: COO

Job Summary

The CMT would be responsible for management of all processes in a Control Room.

Roles & Responsibilities

• Read and interpret diagrams and schematic drawings and related technical information to determine work procedures;
• Perform the assembly, installation, inspection, maintenance, repair and overhaul of  compression equipment;
• Complete ignition analysis, fuel, air, exhaust and engine management systems testing, fault diagnoses and repair;
• Complete reciprocating and rotating machinery analysis to determine equipment condition, prediction to failure, corrective and preventative measures, and equipment performance to design intent;
• Perform visual walk-around inspections to determine the external conditions and obvious operational or safety issues;
• Use a variety of electrical, mechanical and specialty diagnostic test equipment to diagnose problems and adjust engine systems;
• Provide preventative and corrective field mechanical services on the compression, processing and production equipment on-site at the facility

Job Status:

Permanent

Job Specification:

    Bachelors degree in an engineering discipline
    10+ Oil & Gas Experience
    Good practical knowledge of international Oil & Gas norms and standards